Introduction
This repository runs the curl command with the head option to retrieve the header of the specified page.
The commands you need to install
- None in paticular
Quickstart
Run the curl command to retrieve and display the page header information.
ubuntu
Output results
HTTP/2 200
server
date
content-Type
vary
link
set-Cookiemacos
MacPorts
Output results
HTTP/2 200 OK
Server
Date
Content-Type
Connection
Vary
Link
Set-Cookiewindows
WSL2
Output results
HTTP/2 200
server
date
content-Type
vary
link
set-CookieMSYS2 MINGW64
Output results
HTTP/2 200
server
date
content-Type
vary
link
set-CookieProcedure
ubuntu
Click to open details
Advance confirmation
Enter the following command into the terminal and if command not found does not appear, it’s OK.
preinstall
Please install the command that shows “command not found” in the terminal using the following command.
command
Executing the following command in the terminal should output a string similar to the following:
Detail
HTTP/2 200
server
date
content-Type
vary
link
set-Cookiemacos
Click to open details
Advance confirmation
Enter the following command into the terminal and if command not found does not appear, it is OK.
*MacOS uses the MacPorts package manager to manage commands. If you haven’t installed it yet, please refer to the MacPorts installation instructions at the link below. Also, set an alias for the command so that you can call the command without conflicting with the existing environment. If you are using this blog for the first time, please refer to the following two articles to set up your environment.
preinstall
If the command not found appears in the terminal, install it using the following command and set an alias.
command
Executing the following command in the terminal should output a string similar to the following:
Detail
HTTP/2 200 OK
Server
Date
Content-Type
Connection
Vary
Link
Set-Cookiewindows
Click to open details
Advance confirmation
Enter the following command into the prompt and if command not found does not appear, it’s OK.
WSL2
MSYS2 MINGW64
*Windows has been confirmed to work with WSL2 and MSYS2 MINGW64. Please install WSL2 if possible, and if you are unable to set it up, you can run it by installing MSYS2, but there may be some commands that can only be run in WSL2. Please refer to the following article for instructions on how to install WSL2 and MSYS2.
preinstall
If the command not found appears in the prompt, please install it using the following command.
WSL2
MSYS2 MINGW64
command
By executing the following command at the prompt, you should get the following output:
WSL2
Detail
HTTP/2 200
server
date
content-Type
vary
link
set-CookieMSYS2 MINGW64
Detail
HTTP/2 200
server
date
content-Type
vary
link
set-CookieAfterword
This is used when you want to check the server status by getting only the headers in the response header and body.